Recommended Services

Yamaha Factory Recommended Services

100 Hour Service or 1 Year of use
Four Stroke - 4 or 6 cylinder 6 cylinder HPDI Fuel Injected/Carb 4 or 6 cylinder II
  1. Change fuel filters
  2. Inspect fuel system
  3. Throttle link adjustment
  4. Idle speed adjustment
  5. Clean or change spark plugs as nec
  6. Inspect trim system
  7. Inspect engine wiring
  8. Grease all fittings
  9. Change Gear oil.
  10. Check propeller
  11. Inspect Exhaust water passage
  12. Inspect timing belt for wear
  13. Inspect timing chain tensioner
  14. Computer analysis
  1. Change fuel filters
  2. Inspect fuel system
  3. Throttle link adjustment
  4. Idle speed adjustment
  5. Clean or change spark plugs as nee
  6. Oil tank water drain inspection
  7. Oil pump inspection
  8. Inspect trim system II
  9. Grease all fittings
  10. Check propeller
  11. Inspect Exhaust water passage
  12. Remove & replace oil tank filter
  13. Inspect High Pressure fuel pump oil
  14. Oxygen sensor clean. Replace
  15. Computer analysis
  1. Change fuel filters
  2. Inspect fuel system
  3. Throttle link adjustment
  4. Idle speed adjustment
  5. Clean or change spark plugs as nec
  6. Oil tank water drain inspection
  7. Oil pump inspection
  8. Inspect trim system
  9. Grease all fittings
  10. Check propeller
  11. Inspect Exhaust water passage
  12. Computer analysis
Yamaha 4 Stroke 4/6 Cylinder
$200.00 plus parts
Yamaha HPDI 6 Cylinder
$200.00 plus parts
Yamaha 4/6 Cylinder
$200.00 plus parts

 

Mercruiser

Factory Recommended Services
100 hour service or 1 Year of use
Mercruiser V6, V8 5.7/6.2L Engine
300 hour service or 3 years of use
Mercruiser V6, V8 5.7/6.2L Engine
  1. Retorque the connection of the gimbal ring to the steering shaft
  2. Change fuel filters
  3. Inspect steering system/lubricate linkages
  4. Lubricate engine coupler
  5. Inspect the Mercathode system operation
  6. Change lower unit oil
  7. Change transmission oil
  8. Inspect the condition and tension of belts.
  9. Change Engine oil.
  1. Check exhaust / cooling system Inspect manifolds and risers. Inspect exhaust hoses for wear
  2. Inspect & retorque the engine mounts
  3. Check the ignition components for wear
  4. Clean flam arrestor, clean crankcase ventilation hoses. Replace PVC valve as needed.
  5. Check electrical system for loose, damaged or corroded fasteners.
  6. Inspect the condition and tension of belts.
  7. Disassemble and inspect the seawater pump, replace worn parts as necessary.
  8. Clean the seawater section of the closed cooling system, Clean, inspect and pressure test the cap.
Mercruiser V6, V8 5.7/6.2L Engine
$200.00 plus parts
Mercruiser V6, V8 5.7/6.2L Engine
$350.00 plus parts
Mercruiser
Bravo III Corrosion Inspection
Spring Diesel Commission
  1. Inspect Mercathode grounding system
  2. Inspect Battery terminals and output.
  3. Perform out of water Ohm tests
  4. Perform in water Ohms tests.
  5. Check grounding system of the boat.
  • Commissioning of Diesel Engine.
  • Remove and replace fuel filters.
  • Remove & Replace engine pencil zincs.
  • Check belts for wear/tension.
  • Check coolant level.
  • Check alternator output level voltage.
  • Clean battery terminals/check electrolyte.
Mercruiser Bravo III Inspection
$125.00

6 or 8 Cylinder..................$175.00 plus parts
2, 3, or 4 Cylinder.............$125.00 plus parts